---

商品の説明

DarwinFPV TinyAPE Freestyle 2.5" 2-3S FPV レーシング RC ドローン

Tiny Ape Freestyle は、Darwinfpv 向けの最初の 2.5 インチ ドローンです。Darwin ELRS2.0 F411 15A Bluejay AIO と、出力電力が 25 〜 600mW の VTX006 が付属しています。

Specification:
Weight: 50.3g (without batteries and paddles)
Propeller: Gemfan 2512 3-blade propeller
FC&ESC:F411 1-3S 15A FC(Built-in ELRS 2.4G receiver)
Built-in Receiver Protocol: SPI ELRS 2.4G
Motor: 1103 8000KV Brushless Motor
Camera: RunCam Nano 4
VTX :25-600mW VTX
AIO Firmware: betaflight_4.3.0_BETAFPVF4SX1280
ESC Firmware: Bluejay_S_H_50_48_v0.14
Recommended Battery: 2S 380-450mah(not include)
GNB 450mAh 2S HV リポバッテリー 7.6V 80/160C XT30 Plug


The factory AIO firmware only supports ELRS_V2.0, and can be used with ELRS_V2.0 version TX. The firmware file name of ELRS-V2.0 is BETAFPVF4SX1280

Darwinfpv ELRS-V2.0 CLI
Darwin AIO 002 FC Pairing Tutorial

RunCam Nano 4 Camera
The RunCam Nano 4 uses a 1/3'' CMOS sensor, 2.1mm lens and 800TVL resolution for better realistic color and clearer low-light night vision.

1103 8000KV Brushless motor
1103 8000KV Brushless motor is only 3.7g and it’s power and thrust are surprising, and the flight time can achieve about 5 Minutes. We have notice: the motor only supports 2S batteries, and if it is connected to 3S to push the throttle too much, the motor will be permanently damaged .



VTX

VTX006 has 25-600mW output power and can provide stable images and powerful transmission. You can choose the perfect output power according to you FPV requirements. ( The default setting of the output power for Tiny Ape is 400mW)



Flight Control(FC)

This is an updated version of Darwin AIO. We integrated the ELRS receiver on the FC to make it easier to apply to mini drones. The ESC adopts Bluejay firmware, compatible with 1-3S Lipo input, 15A continuous current and 17A peak current. FC provides 2 sets of Uarts interfaces, and also provides various external device interfaces such as SBUS, Softserial, CTR, BUZZ, RGB, etc., which perfectly solves the problem of insufficient number of F411 Uarts.

The built-in receiver is an SPI protocol receiver, so you need to select SPI receiver support (SPI RX support) in the betaflight configurator. Under normal circumstances, the checkbox on the betaflight configurator receiver is empty. If the betaflight configurator used is 10.8.0 and above, the checkbox should select "EXPRESSLRS". As shown below:



セット内容：
1ｘ DarwinFPV TinyAPE Freestyle 完成機
1ｘ系統図付き

**RunCam Thumbカメラとカメラマウントは別売りです
**100g未満 ドローン