WALKERA G-3D Brushless Gimble (HM)

G-3D ジンバル は iLook や Gopro Hero3, Hero3+カメラの設置用です。
注意:上記写真のカメラは付属しておりません。
マニュアル:英語
------------------------------------------------------------------------
Features:

More easy, more stable, more accurate
Smart design and aluminium alloy body
Direct driving brushless motor control and various control angles
Seamless support for iLook, iLook+, GoPro 3 and GoPro 3+
Support iLook, iLook+, GoPro series camera video auxiliary output
Support power supply voltage compensation
Support the motor drive end short circuit protection
Support initial tilt and roll angle custom
Support stick position mode and rate mode
Support regular receiver
Support online firmware upgrade (UP02 and UP02 adapter required)

------------------------------------------------------------------------
Specification:
Operating voltage: DC 7.4V - 28V (recommended 12V, 3S Li-Po battrey)
Operating current: 500mA - 600mA (depends on the voltage supplied and motor power)
Operating temperature: -15°C - 65°C
Sensor: 3-axis MEMS gyro and 3-axis MEMS accelerometer
Control accuracy: 0.02°
Angle control range: -135° ~ 90°(tilt); -45° ~ 45°(roll); -90° ~ 90°(YAW)
Applicable camera: iLook / iLook+ / GoPro Hero3 / Hero3+
Weight: 188g (without camera)
Dimension: 114.3*97.5*106.6mm
Box dimension: 150*127*98mm



この商品を買った人はこんな商品も買っています