SucceX-D F7 V2.1 Stack (F7+60A ESC) [IF-FC07570]

The SucceX-D F7 is designed to work seamlessly with DJI’s new HD FPV system. To make things even simpler, the DJI Air unit can just be plugged into the FC with the included wire harness. In addition, we added the popular and reliable USB Type-C instead of Micro USB and therefore the same standard than your DJI module.

Features

• Universal USB Type C connector instead of micro USB
• Plug-and-Play. No need to solder tiny wires.)
• Supports BLHeli pass-through for easy ESC upgrade and configuration.
• Designed to support DJI Digital FPV.
FC // SucceX-D F7 TwinG

MCU: 216MHz STM32F722
Gyro:2x ICM20689
Baro: YES
Blackbox:32MB
Betaflight OSD: YES
BEC: 5V 2.5A / 9V 2.5A
Current sensor scale: 100
Inverter for SBUS input (UART2-RX)
Smartaudio & Tramp VTX protocol supported
Beeper pad : Yes
RSSI input pad: No
UARTs:5
Motor outputs: 8
8 pin 4in1 ESC port (GND, VBAT, M1, M2, M3, M4, CUR, R5)
6 pin DJI Air Unit port (R1, GND, R2, T2, GND, 9V)
BLHeli32 Telemetry:RX5
Input voltage:recommended 2-6S, MAX 8S
Target: IFLIGHT_F722_TWING
Mounting pattern: 30.5*30.5mm φ4mm with Grommets φ3mm
Dimensions: 36*36mm
Weight: 7.5g
USB type-C
ESC // SucceX 60A V2 4in1

Top Features:
8 layers single-board stacking PCB board
4oz 1.6mm thick power board
32bit STM32FO51K MCU, 48kHz maximum clock speed
TDK MLCC Low ESR ceramic capacitors
Top grade metal MOSFET


【仕様】
MCU: STM32F051
Up tp 48kHz PWM frequency
Capacitance: 470uF/50V
Current Sensor: Yes
Input: 2-6S LIPO
Constant: 60A / Burst: 80A
BlHeli32 telemetry: Yes
BEC: No
Supports up to Dshot1200, Proshot, Oneshot, Multishot
Target: iFlight-BL32-4IN1
Weight:14.4g
Mounting pattern: 30.5*30.5mm/Φ3mm
Dimensions: 43*39mm (including the power pads)

【セット内容】
SucceX-D F7 TwinG FC x 1
SucceX 60A V2 ESC x 1

この商品を買った人はこんな商品も買っています