F4 NOXE V1 (Upgraded) FC + BL32 25A 4in1 BLHeli_32 ESC (DShot1200 / 2-4S / 20x20mm)[08-413]

※このFC はデラックス版です。 バロメーターとブラックボックスがついております。
Firmware: betaflight_4.1.0_FLYWOOF411.hex
1.6mm Thickness PCB
Add 8V 3A dependent BEC
The black box is upgraded to 16MB
Add IIC (SDA, SCL) Port
Add CURT (current signal) input port
Remove PPM Port
Support 2-6S Lipo input
Specification (Flight Controller)
Item Name: Betaflight F4 Flight Controller
Model: F4 Nox4 V1
Version: Standard Version / Deluxe Version
Standard Version: Without Barometer and Blackbox
Deluxe Version: With Barometer and Blackbox
MPU: MPU6000
Input Voltage: Support 2-6S Lipo Input
Firmware: betaflight_4.1.0_FLYWOOF411.hex
Built-In Betaflight OSD
Built-in 5V@2.5A & 8V@3A BEC
Support Spektrum 1024 /2048 , SBUS, IBUS, PPM, and 3.3V Spektrum Satellite receiver
Size: 27x27mm
Mounting Hole: 20x20mm , M2.5
Weight: 4.3g
Application: for less than 150mm frame kit
Used 32bit ARM Cortex MCU STM32F051 48MHZ CPU, 2048 Freq
Support Dshot1200/600/300/150, Oneshot125, Multishot, PWM
Voltage: 2-4S (7.4-16.8V)
Continuous Current: 25A
Peak Current: 30A (5 Sec)
Firmware: BLHELI 32 ESC
Mounting: 20*20MM
Size: 29*31MM (Included soldering pads)
Hole: 2MM
Weight: 5g
Diagram Picture Instruction
GND: Ground
4.5V: Receiver power supply
+5V: BEC 5V 2.5A cont.
8V: BEC 8V 3A cont.
3.3V: LDO3.3V,MAX.150MA
VBAT+: share Lipo power 7.4V-26V(2-6S)
VOUT: Video output for video Transmitter
VIN: Camera Video input
BUZ+ BUZ-: General active 5V buzzer for dbuz 5V
LED: LED_Strip WS2812 LED signal
RX1 & TX1: UART1
RX2 & TX2: UART2
RX2(DSM/IBUS): DSM2/DSMX/IBUS RC Receive(Software Settings RX2)
SBUS: SBUS RC Receive (Software Settings RX2)
RSSI:Receiver signal strength
CAM-C: Camera control
CURT:Current signal input

1x F4 Noxe V1 Flight Controller
1x BL32 25A 4in1 BLHeli_32 DShot1200 ESC (RCX07-761)
1x Cable