iFlight REVO Bee F4 V2 - with OSD Flight Control Betaflight Firmware [IF-FC05269]


iFlight REVO Bee F4 V2 - with OSD Flight Control Betaflight Firmware

F3's upgrade version, using F405 instead of F303, could run faster loop time(double 8K speed).

(Support Oneshot125, Oneshot42, MULTISHOT, Dshot150/300/600/1200 ESC)

Using F4 MCU controls OSD and MPU6000 over SPI bus in DMA mode, OSD Configation has been incl. in Betaflight GUI.

Please write OMNIBUS F4 SD

Features ofREVO Bee F4 V2 compared to V1:

* Telemetry function
* Built in LDO 5V Output, no need extra soldering
* Little bit change on ports

Features:

- Only 36x36mm, mount holes 30.5x30.5mm
- Support: 2-6S
- STM32 F405 MCU, Runs Betaflight 3.0 firmware, Cleanflight compatible
- 5V 1A BEC built
- PWM port reserved, support PWM/SBUS/PPM/IBUS/DSM2 input
- OSD built
- Port for Buzzer,programable LED light, low battery alarm reserved
- SPI Sensor MPU6000
- 128Mbit Flash
- MPU6000 at SPI bus.
- Support SD card

Package included:

- 1 x iFlight REVO Bee F4 V2 with OSDF Flight Control

カテゴリーから探す

コンテンツ