F3 Micro Flight Controller with PDB, OSD & LC Filtered [08-233]

MCU: STM32F303CCT6 (72MHZ, 256K FLASH)
Mounting: 20x20mm (M2.5)
Changed to 20x20mm mounting and M2.5 hole since 2017/02/23
Although the hole is M2.5 but usually M2 Nylon Spacer & Screw are used for installation.
Sensor: MPU-6000
BEC: 5V/500MA
Firmware: betaflight_3.1.0_OMNIBUS
DSHOT Supported
Operation Voltage: 2-3S Li-Po
DSM connects to 3.3V
SBUS & PPM connects to 5V
SBUS & DSM: Use RX3 Port
Support LEDSD (Turn off Transponder before use)
Designed for Brushless Multirotor System

Package Included
1 x F3 Micro Flight Controller