SP Racing F3 EVO Brushed V2.0 Flight Controller for Coreless Motor (Support 6 Rotors) [09-159]

32-bit brush flight controller based on SP Racing F3 EVO firmware
Supports 1S ( 4.2V ) and 2S ( 8.4V ) power supply, 2S can bring you more breathtaking flight
Independent design of the circuit structure, pressure reduction technology whether with 1S or 2S power input, there is 5V output from
UART1 / 2 and 3.3V from UART3
STM32F303CCT6 + MPU6500, the F3 advanced hardware platform guarantees more stable flight
With a large-current NMOS transistors, the operating current reaches more than 10A. Each machine is equipped with freewheeling diodes
Supports input signal of PPM, SBUS, DSM receiver
Has battery voltage detection and buzzer interface
Compatible with almost all coreless motors, including the 1020 motor
The V2.0 supports 6 rotors
Dimension: 22 x 32.5mm
Thickness: 1.2mm
Weight: 3g


DSM受信機を直接DSMの、3.3V, GND, RX3 に半田します。"Cleanflight"の設定は UART3 にして下さい。
PPM と SBUS の場合は、UART2 の GND, + 5V, RX2 に半田し、"Cleanflight"の設定はUART2にして下さい。

Battery Voltage Option (1S or 2S)

Before applying power, pay attention to the battery voltage selection.

The default shipping is 1S (4.2V); When using 2S, first need to disconnect the short contacts 1S, and then put the two pads on the 2S.

Prohibit shorted together the three pads at the same time.

Package Included
1 x SP Racing F3 EVO Brushed V2.0 Flight Controller for Coreless Motor
1 x Double Sided Tape
1 x Battery Cable